10/6 Pentium 90. Comm Ports 1 and 2 already in use. Internal modem.
Jumper set to Comm3. However, in the modem set-up under Control
Panel there is only the option for Com1 and Com2. What can I do to
get the modem to work (aside from using com ports 1 or 2)?
\_ I assuming you're using windows. Try diddling with the settings
for your two serial ports under the device manager. Maybe try
to unhook one of your serial gizmos, disable its serial port, then
use the modem as com<whateverthatwas>, then re-start it. -John
\_ What John said but in English: reconfigure the modem to use port
3 or 4 and disable any other ports via the dip switches that the
modem should use, then try playing with windows settings.
\_ When you say reconfigure, what do you mean? Does this mean
to set the jumper on the modem to com3, or something more
than this? Also, I'm not sure what you mean by disabling
the other ports. First off, why do I need to do this?
Second of all, what do you mean by "dip switch"? Anyway, in
the windows setting, com3 never shows up? Will playing with
the hardware change this? -clueless (no joke) |