11/7 On ultra5's there's m64config to tweak the graphics settings. Anybody
know the equivalent command on sunblade 100s? Users are complaining
about some cad tools' color mapping being different on sunblade 100s
vs ultra 10s. The tools and the monitor are identical. What can
I tweak graphics wise? Thanks.
\_ fbconfig? also, possibly afbconfig or ffbconfig or even m64config.
my sunblade also has an m64. check the output of prtconf to figure
out which frame buffer it uses. --scotsman
\_ This depends on the framebuffer. If you're using the on-board
video connector, then you should use m64config. If you're using
the Expert3D-lite, then it probably needs some other tool for
configuring its settings. |